Arduino SA
  • Learn @ Arduino SA
  • Arduino Introduction
  • Support
    • Setup your Computer
    • Adding Libraries
    • Setting up a ESP32
  • Arduino Robot Car
    • Arduino Bluetooth Car
      • What you will need
      • Circuit Diagram
      • Assembly the Car
      • Upload the Code
      • Bluetooth setup and Test
    • 4WD Obstacle Avoidance
      • Introduction
      • Component List
      • Assembly
      • Component Description
      • Circuit Diagram
      • Computer Setup
      • Line Tracking Mode
      • Obstacle Avoidance Mode
  • Arduino Kits
    • Smart Plant Watering Kit
      • What you will need
      • Wiring Diagram
      • The Code
      • Pics
    • Basic Starter Kit
      • Component View
      • Installing the IDE
      • Add Libraries
      • Blink
      • Button Control LED Delay Switch
      • Active Buzzer
      • Passive Buzzer
      • Servo
      • IR Remote and Receiver
      • Stepper Motor
      • Eight LED with 74HC595
      • LCD
      • Digital tube with Traffic Light Experiment
      • Four digit tube display
      • LM35D Temperature Sensor
      • LDR 5516 experiment
      • Flame Sensor
      • 8 * 8 LED Module
      • Controlling Stepper Motor With Remote
    • Super Starter Kit
      • Tutorials
    • Best Beginner Kit for Arduino
      • Tutorials
    • Uno R3 RFID Kit
    • WIFI ESP32 IOT Kit
    • Arduino Ultimate Starter Kit
  • Blocking Coding Lessons
    • Beginner Lessons
      • Setting up mBlock
      • Blinking an LED
      • LED Switching
      • LED Chasing
      • Traffic Signal
      • Buzzer
      • Buzzer + Push Button
      • LED + Push Button
  • Sensor Kits
    • 37-in-1 Sensor Kit
      • Joystick
      • Relay
      • Big Sound
      • Small Sound
      • Tracking
      • Avoid
      • Flame
      • Linear Hall Sensor
      • Touch
      • Digital Temperature
      • Buzzer
      • Passive Buzzer
      • RGB LED
      • SMD RGB
      • Two-Color 5mm
      • Two Color 3mm
      • Reed Switch
      • Mini Reed
      • Heartbeat
      • 7 color flash
      • Laser emitter
      • PCB mounted push Button
      • Shock switch
      • Rotary encoder
      • Light Cup
      • Tilt Switch
      • Rolling ball tilt switch
      • Photoresistor
      • Temp and Humidity
      • Analog Hall
      • Hall Magnetic
      • Temp
      • Analog Temp
      • IR Emission
      • IR Receiver
      • Tap Module
      • Light blocking
Powered by GitBook
On this page

Was this helpful?

  1. Sensor Kits
  2. 37-in-1 Sensor Kit

PCB mounted push Button

PreviousLaser emitterNextShock switch

Last updated 3 years ago

Was this helpful?

A built-in 10 K ohm resistor is connected between the centre pin and the ‘S’ pin and can be used as a pull up or pull down resistor. The push button connects the two outer pins.

The Button.h library (available from Arduino) is suitable for use with this.